Dorchester 2

/Tag: Dorchester 2

Dorchester 2 Freedom Gray Copper Ornamental Decorative Downspout Bands Straps

Rate this post

Part 2 of 4 Parts for this order. 50 the first time and 60 for this time.

Dorchester 2 Freedom Gray Copper Ornamental Downspout Bands Straps

Dorchester 2 Freedom Gray Copper Ornamental Downspout Bands Straps
5 (100%) 12 votes

Dorchester 2 Freedom Gray Copper Ornamental Downspout Bands Straps

This is 50 of our New Dorchester 2 Ornamental Decorative Copper Downspout Bands Straps. Quite a bit of work to accomplish this job in Freedom Gray Copper…
This Project will take a Year or more to accomplish. This is just the first leg of the journey. They are for Harvard and our Friends at Titan Roofing. We have made Hundreds of Bands so far for various Buildings at Harvard. And hopefully Hundreds more!

Want to take a peek at how these band got developed?
Link to see the entire process from start to finish: 

Dorchester 2 Freedom Gray Copper Ornamental Downspout Bands Straps

Dorchester 2 Freedom Gray Copper Ornamental Downspout Bands Straps
5 (100%) 10 votes

It’s Sunday and making a Second Band for the Builder this time now…..This project has been a couple months in the works…

We had some minor issues that we will be correcting on the second band. The radius for the Front and Sides (same die sets) were just a little bit off where we would like them to be. Made the corrections.
If you look really close in the end view of the parts you can see the tear drop shape as opposed to a true radius….Fixed! Should be ready to roll now….

Just have to get a final count. Was about […]

Dorchester 2 Freedom Gray Ornamental Copper Downspout Bands Straps

Dorchester 2 Freedom Gray Ornamental Copper Downspout Bands Straps
5 (100%) 4 votes

Dorchester 2 Freedom Gray Ornamental Copper Downspout Bands Straps

This will take awhile for this project as we are starting at Ground Zero. First was design of the Bands and then do the necessary CAD work to get the raw Die Set blanks laser cut.

Got a lot done actually. The Button looks good for roughing in.

Day 2

Working on die sets for the faces and sides (actually its the same die set as they are the same shape just different lengths and miters for the parts they will make).

Ok. Proved out the blank needs to be 5-3/16″ wide and had […]

By |2019-03-12T22:55:04+00:00July 21st, 2017|0 Comments