Call Us 248-791-7949|info@coppershoppe.com

Robert Anthony

/Robert Anthony

About Robert Anthony

Hello, While I may own the place... I will still sweep the floors and take out the trash... I know that every single thing to make a great product starts with knowing that EVERY THING needs to be done from start to finish with no stones left unturned.
Email

HRC Double Tab Copper Gutter Brackets

HRC Double Tab Copper Gutter Brackets. This was tricky. They have to mount to a 2″ by 4″ fascia. Not a lot of room to account for slope. These brackets are for a good customer who has purchased 1000’s of brackets. You will notice in a few pictures a “Chamfer Bit”. We are supplying this bit to him so if he needs it to do some more chamfering he can do it more easily. Chamfering holes removes material and that hole at the top rear of the bracket has to accept a #12 Screw. We pushed the limit to what […]

By |2020-10-24T13:45:53+00:00October 24th, 2020|Copper Gutter Brackets|0 Comments
Read More

Fleur-di-Lis 2 Ornamental Decorative Copper Downspout Bands Straps Hangers

Fleur-di-Lis 2 Ornamental Decorative Copper Downspout Bands Straps Hangers.
Notice the Brass Sheet Metal Screws. We supplied these to the customer as they are difficult to find.
Notice the picture of the 5/64″ drill bits. Pilot hole must be drilled first before you run the screws.

By |2020-10-21T12:55:29+00:00October 21st, 2020|Ornamental Copper Downspout Bands|0 Comments
Read More

Round Copper Chimney Flue Caps

Round Copper Chimney Flue Caps. Three for this project. Two for 15.5″ diameter flues and one for 20″. You will see in the close up picture of the mounting screws that we put a point on them. Normally the caps are shipped with the mounting screws in place but these will be fitting over flues with nosing and they would get in the way at that point. So best to put them in once the cap is in place. You will see two wooden dowel rods. Those are to fit through the screening and then rest on the top of […]

By |2020-10-12T13:07:49+00:00October 12th, 2020|Chimney Caps|0 Comments
Read More

Winthrop Ornamental Decorative Copper Downspout Bands Covers

Winthrop Ornamental Decorative Copper Downspout Bands Covers
While these fit 4″ Round Downspouts the customer requested an additional 1/4″ in depth

By |2020-09-24T17:20:15+00:00September 24th, 2020|Ornamental Copper Downspout Bands|0 Comments
Read More

AutoClear HV High Water Volume Copper Downspout Leaf and Debris Diverter Filter Clean Out with Max Door

AutoClear HV High Water Volume Copper Downspout Leaf and Debris Diverter Filter Clean Out with Max Door.
This is the Unit going to Florida.

By |2020-09-29T23:26:46+00:00September 17th, 2020|AutoClears|0 Comments
Read More

AutoClear HV High Water Volume Copper Downspout Leaf and Debris Diverter Filter Clean Out

AutoClear HV High Water Volume Copper Downspout Leaf and Debris Diverter Filter Clean Out
We just prototyped this unit for a customer that has an extremely high volume of water flowing through his downspouts.
He is located in Florida in an area that has large homes and very heavy downpours. Large homes mean large roof areas and sometimes the roof area to downspout ratio is not the best – so the need to have a unit that can handle the volume.

We took an I-Series unit and removed the standard 4″ Outlet (fits to 4″ Drain) and replaced it with a 5″ Outlet […]

By |2020-09-17T14:30:42+00:00September 17th, 2020|AutoClears, Brasstonian AutoClears, I-COPPER|0 Comments
Read More